RE14010C2D REV A Amana Air Conditioner Parts List

Replacement ice maker (icemaker drive motor)

This ice maker is the replacement heat-release unit only. This kit comes with four round female connectors at the end of the wire harness. It also comes with the adaptor that converts the harness to three round female and one round male connectors. This is a genuine OEM part. Please make sure you disconnect the power to the refrigerator before starting your repair.

White dishrack roller (white dishrack roller - just over an inch in diameter)

This upper dishrack roller is just over an inch in diameter and the axle that clips to the roller is an inch wide. It is all white in color and is made entirely of plastic. The upper roller allows you to move the dishrack easily on the support rails. No tools are required for this repair. This is a genuine OEM part.

Meat drawer (pan, meat)

Sold individually.

Light bulb - 120v 25w (sub a3073101)

This 25-watt, 120-volt light bulb is 2.5 inches long. It has a small, screw-in base and it is used in many different appliances. If your current bulb is burnt out or broken you will need to replace it. This light bulb is a genuine OEM part and is sold individually.

Pantry end cap - right side (endcap, rh pantry)

This part mounts on the wall and is used to support the pantry drawer.

Agitator repair kit (cam, driven)

This agitator repair kit comes with a long cam, a thrust spacer and four dogs ears (agitator cogs). This repair kit is used to move the upper agitator and it connects the base of the agitator with the agitator top (mover). This part has been updated by the manufacture.

Control knob (control knob asm)

Door shelf retainer

Sold Individually.

Water inlet valve (valve-water)

When energized, the water inlet valve will release water from the supply line into the ice mold and the water dispenser in the refrigerator. If the ice maker is not making or dispensing ice, not dispensing water, or leaking, you may need to replace the water inlet valve. The water inlet valve is in the back section of your refrigerator and will need to be pulled out from the wall. Make sure to disconnect both the water and power supply before starting your repair.

Shelf support stud - white (shelf support stud)

This kit contains two options - One that is a push and turn and the other that is a screw in.

Capacitor (refrigerator run capacitor)

The run capacitor is attached to the compressor. This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer. If your refrigerator is too warm, will not start, or your freezer section is too warm, you may need to replace this part. This is a genuine OEM part. Please remember to disconnect power to your refrigerator before starting your repair.

Crisper pan - large (sub 67001503)

Sold individually. Front Width: 16.8; Front to Back: 14.9"; Width at Rear: 16.42.

Door shelf end cap - right side (door shelf end cap)

This white end cap is a little over two inches long. It is used for the right side of either the refrigerator of the freezer door shelf.

Light bulb - 10w (bulb, light)

This ten watt appliance light bulb is two inches tall. It is used with both washers and dryers.

Crisper cover with glass (refrigerator drawer cover)

This part is also known as a shelf frame. This drawer cover is for refrigerators. Drawer cover has rail brackets under the cover that hold the drawer and allow the drawer to slide in and out on the rails. Follow the instructions in the owner's manual or installation guide when installing this part. This comes with glass.